1 / 5
Top Wire and PTFE tubing support for cut-off PTFE on SOVOL SV08 — image 1
1 / 5

Top Wire and PTFE tubing support for cut-off PTFE on SOVOL SV08

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Supports Top wiring harness and PTFE tube when tube is cut short on SV08.

Rating
0 / 5
Likes
5
Downloads
39
Makes
0
Views
349
Reviews
0

Updated at source:

Model information

License
Creative Commons — Public Domain

UPDATE:  Added side angled support to the PTFE tube to keep it from bending toward filament feed and 1mm feet on bottom to stabilize it a bit more.  Print with ABS or similar heat-resistant filament and include supports, then remove support under bottom.

 

I did not like how the wiring harness and ptfe tubes were too easy to pull to the side of the filament roll, so I designed this support to put on the top of the toolhead.

It helps to hold the wire and the ptfe tube more upright when there is a pull on them from the roll.

This is for when the PTFE tube has been cut off to allow for easier filament loading.

Remove the filament from the PTFE tube.

Snap the support onto the PTFE tube (or slide it down the tube) while also inserting the wire from the side of the slot.  Press them both in gently with pliers or your fingers.

Slide the support down to the top of the toolhead.

I used one of the SOVOL-supplied wire snaps/twisty things to hold the PTFE tube securely in place, and a short twist-tie to hold the wire in place.

Tags