Mounting Bracket for LED Strips

Mounting Bracket for a rather affordable LED Strip by Huemihui

I didn't want to spend 37€ on proper light in the shadowy prusa enclosure, so I opted for nice generic diffuse LED stripes. The LED stripes are clicked into the mounting brackets, which can be screwed into the ceiling of a Prusa Enclosure. As usual - sharing is caring, so here's my design files. I also added the FreeCAD source, in case you need to do some modifications.

Additional Parts required

For each strip will also need: 

• 2 M3x4 screws (e.g. M3x4 out of your Prusa Enclosure Kit)
• 2 regular M3 Hex Nuts (e.g. M3n out of your Prusa Enclosure Kit)
• LED Strips (roughly 10€, Affiliate Link) - you will only need half the set https://amzn.to/3ViVG1k
• some Cable Ties

Assembly Instruction

• Print 4 of the parts. I suggest using Prusament PETG and 0.10 Fast Detail Slicer Settings
• Insert M3 Hex Nuts into the Parts, if you already set up your Prusa Printer you already know the drill…
• Use the holes in your Prusa Enclosure and the M3x4 Screws to secure the mounting brackets into the ceiling of your prusa enclosure. Do not entirely tighten the screws yet
• snap the LED bars in place
• tighten the screws
• set up the wiring and secure it to the cable tie notches in your prusa enclosure
• connect power
• let there be light

what to do next

• well, enjoy your well-lit enclosure
• print and mount a clamp for the LED controller
• happily print along
• create a project for the remaining 2 LED strips in the set you bought
• if you want to share some of the money you saved you may support me on ko-fi if you like https://ko-fi.com/dickenhobelix