1 / 4
FLSUN v400 5015 Dual Fan Ducts — image 1
1 / 4

FLSUN v400 5015 Dual Fan Ducts

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

FLSUN v400 5015 dual fan ducts. Remixed from ChrisCampbell's and Nyndroth's models.

Rating
0 / 5
Likes
13
Downloads
85
Makes
0
Views
464
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Introduction

This model allows for the use of dual 5015 fans on the FLSUN v400. The dimensions were based on ChrisCampbell's FLsun v400 Cooling Fans 5015 Adapter and Nyndroth's remix. The front fan cover remains unchanged and also allows for mounting a fystec adxl sensor for input shaper calibration. All connections are made with M3 bolts using heat-set inserts (OD4.6mm L5.7mm).

 

Printing Instructions

This model was printed out of eSun PLA+. The duct parts need to be printed both in normal and mirrored variants.

Front Support
  • Layer Height: 0.2mm
  • Walls: 2
  • Infill: 15% Cross Hatch
  • Seam Type: Normal
  • Brim: None
  • Supports: Normal, not in the hole
Back Support
  • Layer Height: 0.2mm
  • Walls: 2 
  • Infill: 15% Cross Hatch
  • Seam Type: Normal
  • Brim: None
  • Supports: Normal, not in the hole
Fan Cover
  • Layer Height: 0.2mm
  • Walls: 2
  • Infill: 15% Cross Hatch
  • Seam Type: Normal
  • Brim: None
  • Supports: Normal (the ones on the side are probably not needed)
Top Ducts
  • Layer Height: 0.2mm
  • Walls: 10 (so that it is all walls)
  • Infill: N/A
  • Seam Type: Conditional Scarf (if available)
  • Brim: None
  • Supports: Tree
Bottom Duct
  • Layer Height: 0.2mm
  • Walls: 2
  • Infill: 15% Cross Hatch
  • Seam Type: Conditional Scarf (if available)
  • Brim: Enabled
  • Supports: Tree

 

Assembly Instructions

  1. Insert 3mm heat-set inserts into the front and back supports and the fan cover. Use inserts with OD4.6mm and Length 5.7mm or similar.
  2. Arrach ADXL sensor to fan cover
  3. Attach fan cover and from support
  4. Arrach bottom ducts
  5. Attach fans to top ducts
  6. Attach top ducts to bottom ducts
  7. Attach back support
  8. You might want to redo the input shapper calibration since the effector's inertia has changed. 

 

Tags