Hoyt Powermax GOPro Riser Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wanted to mount my GoPro on my bow for hunting. This fits the third hole down on the riser of a Hoyt Powermax.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 28
- Makes
- 0
- Views
- 586
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted to mount my GoPro on my bow for hunting. This fits the third hole down on the riser of a Hoyt Powermax. As you see in the pictures it screws together decently. The parts shown are the prototype parts in PLA. I would suggest using a high infill percent and extra perimeters for strength. Just in case you bump it or whatever while using it. I know the pictures show the base sticking off the shelf a bit but I figure that considering how crazy strong the adhesive is on the GoPro bases it should be fine. I didn't want to have the shelf stick out too far for fear it would weaken it too much. This is my first attempt at using a picture to make a model in Fusion 360. So go easy on me :) STL's are orientated how I think is strongest. Obviously you do it how you want. Open to suggestions on how to do it differently.
Hardware required:
2 M3 x 25 socket head bolts
2 M3 hex nuts
1 M3 x 18 socket head bolt (hole is self taping for this one)
Print instructions
No specific settings. Suggest 4 perimeters and 20% infill using PETG or better. PLA not recommended.