1 / 13
Prusa MK4/MK4S Bed Test
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This a simple way to test if you mesh bed leveling is working. It can also clear any gunk that is stuck to the bed...
- Rating
- 5 / 5
- Likes
- 120
- Downloads
- 967
- Makes
- 3
- Views
- 2,971
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This a simple way to test if you mesh bed leveling is working. It can also clear any gunk that is stuck to the bed to get a clean print bed.
I recommended speeding the first layer speed in prusaslicer to make the print go a bit faster. The premade gcode is set to 150mm/s, but you can speed up the print or slow it down. I recommend 150-200mm/s.
Prints in less than 30 minutes and only uses 13 grams!
Printing Settings:
| Resolution : | 0.2 | Support: | No |
| Infill : | 100% | Raft: | NO |
| Material: | PLA | Filament Designation : | ANY |
More designs
Tags
prusacleanupprintoriginalprinterfastplaeasybedcleaningpetgfirstlayercalibrationbedlevelcleangcodefullyprintableprusasliceroriginalprusaeasyprintprintbedprintercalibrationbedlevelingmk4plafilamentfirstlayerfullbedleveltestfirstprintbedlevelcalibrationfirstlayertestbedlevellinglastmeterslastmeterbedtestpetgfilamentlastfilamentlastmeterprintoriginalprusamk4mk4sbedcleanerprusamk4sprintreadybedcleaningfullbedmk4smodlastgramsprintcleanfirsttestmk4testcleanprinterbedcleanfullbedtest