Scroll Saw Sanding Strip

----------------------------------------------------------------------------------------------------------------

Please leave a comment with feedback or general discussion regarding the model!!!

----------------------------------------------------------------------------------------------------------------

Description Make your own scroll saw sanding strips! I found them to be too pricy for how prone they are to breaking. Read the printing and assembly instructions bellow to minimize troubleshooting and get to sanding!

Printing instructions 

- Material: I printed these out of ABS, In my tests I've found that the sand paper itself is much weaker than the plastic, so you might get away with using PLA. 

- Print settings: I increased the wall loops to 10 to cover the whole interior, essentially doing 100% infill, but stronger. Enable regular support and use a brim if needed. 

- Print orientation: I i tried printing it in both directions (Link set vertically and Link laid flat). I think both options are similarly strong (I will edit this if I learn anything during use), so set it in whatever direction you think your printer will best handle. 

- Hotend: I used a stainless steel 0.2mm nozzle, but you can use 0.4

Assembly instructions

- Cut the sandpaper into ~6.5cm strips 

- Cut the strips to length (for my 16 inch scroll saw, I cut the strips to 3.75" in length (sorry for metric and imperial (sorry not sorry))) 

- Apply superglue to the edge of the sandpaper strip and insert it into the printed hook. wait for it to set or spray quickdry solution. - Repeat for other side

- Ball out on da sander