Mora Eldris Belt Clip

Remixed from https://www.thingiverse.com/thing:4483913 by superPorp (thanks!) - the original is great and fits snugly/perfectly, great design.

I wanted one that I didn't have to remove my belt to clip on/off so I made an open slot.

The down side is that this version is significantly weaker than superPorp's because there is only one leg handling the stress and the easy print direction has the layer lines perpendicular to the to the force direction which makes it easy to shear. I broke my first print (15% infill) when inserting the knife into the sheath and pressing down to lock it in place. Apparently that's too much force for my design but I've since reprinted it at 50% infill and it's a bit stronger. You can print it "on its side" for better strength but you'll need a ton more supports. Or, you can just grasp the ridge on the belt clip with two fingers while seating the knife with your thumb so the force isn't transferred to the clip... you do you.

There are two STLs - one for 38mm/1.5" and one for 45mm/1.75" belts. Most people will probably want the 38mm/1.5" version but I use a 45mm belt on my hobby pants so I needed a larger one.