1 / 5
DIY Battery Bank Case for IP5310 + 5x 18300 LiPo's — image 1
1 / 5

DIY Battery Bank Case for IP5310 + 5x 18300 LiPo's

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Repurposing 18300 LiPo battery cells from "disposable" vapes into a reusable battery bank.

Rating
0 / 5
Likes
6
Downloads
42
Makes
0
Views
552
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Foreword : Do this at your own risk, LiPo's can be spicy : )

Note that this case is designed specifically for 5x18300 cells and the IP5310 charge controller!

I hate seeing useful electronics go in the trash so I collected several “”disposable"" vapes from friends and harvested the LiPo batteries for projects.  Since they'd been sitting in my electonics box for awhile, I decided to whip up a quick use for them as a USB battery bank.

While the micro-USB 134N3P charge controllers are very common, I wanted USB-C input charging so I went with the IP5310.

The LiPo's are 5x18300's @ 3.7v / 2.96Wh (aka 800mAh) in parallel resulting in a total estimated capacity of 4,000mAh… not too shabby.  

The top and bottom of the case fit together with friction alone.  If you'd like it to be more permanent, just add a dab of CA or hot glue.  A tab is modeled into the top of the case that allows you to easily pry it off from the bottom section.

There is a back stop and under support for the IP5310 board modeled in so you don't have to permanently affix it in any way.  But, if the small bit of play annoys you then you could add a bit of hot glue.  This was fine for me, though I suppose it'd be easy enough to extend the underside board support to allow screw mounting.

Notes : Depending on your printer and settings, you may need to sand the areas where the top and bottom of the case engage for a properly snug friction fit.

Improvements : I used a very opaque filament which means you can't see the charge status LEDs when assembled.  At some point I might consider adding a viewing window so it's easy to check the state visually.  But, it's simple enough to pop the top off using the included tab so not really a big deal for me.

Tags