1 / 4
PTFE tube Y-connector without push fittings
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Jonathan Prt's original splitter had tolerances too tight for my printer, so I redrew it for a looser fit.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 130
- Makes
- 1
- Views
- 467
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is based on the one by Jonathan Prt but with looser tolerances and bent channels for the filament. Specifically, I increased the diameter of the holes by 0.4mm instead of 0.2mm. The channels for the filament are slightly bent to have orthogonal outlets to the PTFE tubes.
I completely redrew the connector in FreeCAD. The file is included for you to adjust the model if needed.