1 / 4
PTFE tube Y-connector without push fittings
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Jonathan Prt's original splitter had tolerances too tight for my printer, so I redrew it for a looser fit.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 129
- Wydruki
- 1
- Wyświetlenia
- 463
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (20)Powiązane
This model is based on the one by Jonathan Prt but with looser tolerances and bent channels for the filament. Specifically, I increased the diameter of the holes by 0.4mm instead of 0.2mm. The channels for the filament are slightly bent to have orthogonal outlets to the PTFE tubes.
I completely redrew the connector in FreeCAD. The file is included for you to adjust the model if needed.