Fume Extractor w/ Detachable Duct
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Attachable duct hose for NM96's fume extractor. Reprint for full function, or just screw in directly to existing print.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 40
- Makes
- 0
- Views
- 400
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
A fume extractor per NM96's design modified to accept a detachable duct hose such that extracted air can be directed out of a window or a vent. Attachment can either be attached via a hook and clips (use 18 gauge wire to fashion the latch like in pics, using the included box to help bend it - I drilled small in the side to grip it), or be screwed in permanently via heat inserts on the back of the extractor - may as well have both options, I figure. The 4" duct hose gets anchored to the back attachment via a simple metal tie that these typically come with.
Finally, the extractor can be attached to a desk lamp arm (like this one) via holes in the base.
This could be upgraded with a back half foam piece to fit directly under a window, with potential for another fan to expel the air at the end, and/or another fan in the hose attachment to make for a push/pull system. Neither is necessary for my purposes, so I probably won't bother making them.
Print extractor and attachment on their circular faces with organic supports - infill and print height shouldn't really matter. Print latches 15mm height on one side with snug supports.
Some pieces might need cajoling/adjusting. I used a cut 3mm rod for the latch hinges, but you could just use M3 screws. Feel free to comment pre-print with questions/concerns.