Marble Maze #1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Took a crack at my own marble maze for my kids. Worked pretty well!
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 106
- Makes
- 0
- Views
- 379
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Puzzles & Brain-teasers
- License
- Creative Commons — Attribution — Share Alike
Kids are going through a Maze Phase and decided to use some of the ball bearings I had purchased for other projects to work.
Designed by pixel in photoshop with 4mm steps in place for use with an 8mm Bearing (4mm walls, 8mm path) , HOWEVER first time I went to print on my new bambu found out that it is not truly 256x256mm print bed, but with a corner lopped off… so scaled it to 21x21cm for a 6mm bearing. Could probably scale slightly smaller and would still work.
Included a bit of a cubby bottom left to hold the bearings when not in use.
Feel free to print and give as gifts/sell, but it took a number of hours to create, so at minimum please leave my watermark and post all your makes! :-)
Prints fine in Draft mode, 2 perimeters,
I was being stingy with filament and did 10% infill with 3 top layers and there was some SLIGHT issues at a very fast print speed, so id suggest a 15% infill to ensure a smooth roll, or 4 top layers. (whatever will provide a smooth top layer on your printer)