Penguin Peril Game - Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for the Penguin Peril Game thing:5171512
- Rating
- 5 / 5
- Likes
- 29
- Downloads
- 78
- Makes
- 0
- Views
- 1,417
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution — Share Alike
I printed the Penguin Peril Game which was released on Thingiverse from Polymaker.
https://www.thingiverse.com/thing:5171512
But I needed a case - so i draw one. You could store more stones that needed and two hammer.
Before you print check the fittings - do a test print - I provided a “cut” from the STL (Fitting_ test_print.3mf). Takes only 5 min and you know if you stones fit into the case easily.
I needed to go up in x and y for 3% - I did it direct in the slicer.
The LID is about 0,2mm bigger - for me it was fine. If you printer fail at a tolerance test with 0,2mm than you should increase X and Y for the Lid a little bit!