1010 T-Slot Extrusion Mounting Brackets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Low profile brackets to mount 1010 (1in x 1in) T-Slot extrusion profiles to a flat surface (like a desk).
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 118
- Makes
- 0
- Views
- 551
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed brackets to mount a t-slot extrusion rail to the underside of my desk while leaving at least one slot unobstructed - but why buy expensive hardware and t-nuts when I can instead over-engineer a solution instead?
I've included an end-cap model, and a model to use as a mid-support for longer extrusion profiles.
Please note, this is specifically for the 1010 / 1in x 1in profile, and the screw holes are sized for #8 screws (0.164 inches / 4.19 mm) because… that's what I had on hand.
I recommend using at least 3 perimeter walls, but PLA or PETG should be more than sufficent.