DJI O4 cam/antenna mount iflight chimera 7 pro
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I could not find any upgrade kit for the iflight chimera 7 pro for the DJI O4 Pro. This is a cam and antenna/GPS mount.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 234
- Makes
- 1
- Views
- 1,059
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I designed and created two components: a camera mount with a TPU soft mount and a GPS/antenna mount.
The camera mount itself was printed in PETG, while the soft mount was printed in TPU with 100% infill. The original DJI cable was slightly too short, so I had to position the camera closer to the center. As a result, the propellers are barely visible—about 2mm of the left propeller appears on the screen. Once I receive a new MIPI cable, I’ll update the camera mount.
The GPS/radio board mount requires support structures during printing. This component was also printed with 100% infill. I used M2x4mm metal inserts for securing the battery cable plug, and there’s sufficient space for an M2x20mm screw. While it’s a bit tight around the power plug, I’m confident it will stay secure. The GPS mount is designed for a GPS unit measuring 21x21x8mm. I use an HGLRC M10 GPS, and it fits well. Additionally, I use a Radiomaster RP3 ELRS RC link, and the antennas fit nicely. Note that this setup is not compatible with the stock side cover.
