1 / 7
Adjustable Angle Hygrometer Thermometer Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tired of bending down to get the right viewing angle for your hygrometer? Tilt the hygrometer instead!
- Rating
- 5 / 5
- Likes
- 49
- Downloads
- 226
- Makes
- 7
- Views
- 523
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Standard Digital File License
Adjustable Angle Hygrometer Holder! Tired of bending down to get the right viewing angle for your hygrometer? Tilt the hygrometer instead!
Open Back design: does not block any sensors and the battery is swappable without removing the stand. No additional hardware is needed. Fast and easy print- Only 7.5 grams.
Print recommendations:
- Split to objects in slicer, print in place, no supports, no brim
- 0.2 layer height, 2 walls, 15% infill
- Make sure build plate is clean!
Installation:
- Split to objects in slicer, print in place, no supports, no brim (make sure the build plate is clean).
- After printing, rotate the housing in the base. A bit of force may be needed to loosen the joint.
- Push the hygrometer in the housing; the tabs will snap in and lock the hygrometer in the housing.
- NOTE: the fit will be tight- it is recommended to insert the hygrometer into the side away from the build plate.
Removal: (see last picture for hand position)
- With hygrometer facing away from you, put index and middle finger nails on both sides of the housing.
- Point towards soft object. Push firmly on the back of the hygrometer with your thumbs. The hygrometer will pop out of the housing.
For use with Rectangular Hygrometers that you can get on Amazon.