1 / 6
ESP32 Max v1.0 Garage Door Housing w/Relay — image 1
1 / 6

ESP32 Max v1.0 Garage Door Housing w/Relay

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€4.15 – €5.08 net (excluding VAT)

For file: ESP32 Max v1.0 Garage Door w Single Relay-Base-Lid_R1_3h56m_0.20mm_200C_PLA_ENDER5S1.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €4.61 excluding VAT (range midpoint).

Weight reported by the author
72 g
Print time reported by the author
3.93 hr
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

Mounting box for an ESP32 Max v1.0 (Arduino UNO Clone) dev board, one (1) single channel relay, and BMx280 Sensor.

Rating
4 / 5
Likes
6
Downloads
31
Makes
0
Views
384
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

This is a basic box to mount an ESP32 Max v1.0 Development board (Arduino UNO Clone) with a single channel 5V relay and a BMP280 temperature sensor (should work w/BME280 as well) to interface with a garage door opener utilizing a momentary push switch/button terminal on the garage door operator/motor.  Wiring is as simple two wire loop/circuit from the relay common and normally-open (most common) terminals.  ESP32 can be flashed w/ESPHome to work w/HomeAssistant.  Box lid is a friction fit to base.  No hardware or glue required.  Print flat on build plate, no supports required.  Screws used to secure components were M2x5mm and standard breadboard jumper wires were utilized.

Links to items used below.

Tags