Onewheel XR 16 pin Molex converter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Converts the 16 pin molex plug on the stock XR box or aftermarket box with MX150 16 pin bulkhead connector.
- Rating
- 4 / 5
- Likes
- 1
- Downloads
- 30
- Makes
- 1
- Views
- 207
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Edit: Added requested variant with just the 20mm cable gland. Included .step file.
Requires NO modification to your stock XR controller box!
There are some other 16 pin molex conversion prints out there, but I wanted to cram in some additional connectivity with a modern VESC layout.
The following ports are plumbed through:
20mm hole.
12mm hole.
Bulkhead XT60EW-M.
The 20mm hole is intended for your battery harness to pass through into the controller box. I used the common stainless steel M20 gland available. The 12mm hole I used for a GX12 6 pin connector for external access to programming pins and other future expansion. The waterproof XT60 connector plumbs vamp-and-ride (external/backpack parallel pack) or charge-and-ride (same as VnR with a voltage booster) to achieve ‘time machine’ riding.
Use 2x M3 bolt, nut, washer to affix the adapter plate in place in the stock XR box.
With appropriate use of your choice of gasket maker, this part will be waterproof.
Contact for alternative licensing – my goal is contributing to the open onewheel community and encouraging easy access.