V6/M6 3d printed nozzle maid for your heatblock
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wanted to print abs nozzle to print pla with, but turns out, i unintentionally created a printable heatblock cleaner!
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 12
- Makes
- 0
- Views
- 63
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
So i decided to print a nozzle out of ABS with a 0.15mm nozzle to push PLA through for kicks, set it first to 60c, then 100c while i kept pushing pla through it, set it to 120c, wiggled nozzle, noticed it was now literally wet spaget/as loose as a primary tooth about to fall out, so i turned off the heat immediately, waited till 50c, when it had harden again, carefully loosened it, and it was surprisingly easy to unscrew, because it had now shaped itself properly after the threading, and it appears it had also bonded with any and all the dirt in the threading, thus the threads in there are now super clean!
So i ended up creating a new way to clean your heatblock from any dirt and debree that might be stuck in there from old clogs, or dust/debree from filaments pushed through in the past.
So for the steps:
Print nozzle in whatever material you desire with a 0.3, 0.2, 0.15mm or as small as you're able to with still good looking threads, insert the 3d printed nozzle into the hotend while cold, start at 50c, and incrementally increase temperatures until you can wiggle the tip of the nozzle with no effort, at that point, the upper part is now fully soft/gooey, and should have “bonded” with anything between the plastic and the threads of the heatblock.
Turn off the temperatures of the printer, and wait until hotend is at 50c and properly cold again.
Carefully use the nozzle removal tool and loosen it. If you can now loosen it with no effort, simply remove it with your fingers as it will neatly glide out as you unscrew the rest.
All rights to nozzle 3d model itself reserved to Stefs Engineering for his step files i used to export as STL.