Kung Fu Flash Cartridge Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This cartridge case is designed to fit revision 1 of the Kung Fu Flash cartridge for the Commodore 64.
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 502
- Makes
- 8
- Views
- 2,064
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This cartridge case is designed to fit revision 1 of the Kung Fu Flash cartridge for the Commodore 64.
For the included "key caps" to fit, use tactile switches with a height of 5 mm. The right most cap shown in the photos was printed using transparent filament. This allows it to act as an optical fiber for the internal LED on the circuit board.
A 3x16 mm self-tapping screw is required to connect both halves of the case.
Update: I added two additional files for revision 2 of the cartridge. This revision allows for the USB connector to be properly accessible!
Please note the license for this design! It does NOT allow for commercial use.
Print each half of the case with its outer surface facing down onto the print bed. The bottom half does not require any support. For the upper half, support might improve the quality of the label field.
The plungers don't require support either, but you might need to use rafts to make them stick to the print bed.