1 / 3
Finger Hex Wrench - 4mm and 1/4-inch
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Finger hex wrench for screwdriver bits with two shank sizes -- 4mm and 1/4-inch. Low profile and a fast and easy print.
- Rating
- 5 / 5
- Likes
- 57
- Downloads
- 273
- Makes
- 5
- Views
- 965
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Remix of the very cool "Finger Hex Wrench" by RonaldWalters at https://www.thingiverse.com/thing:3985566
I wanted to challenge myself and do a complete from-the-ground up redesign (reimplementation?) of the original finger wrench in OpenSCAD.
Here are some changes and improvements I made:
- Still has 1/4-inch hex version
- Addition of a 4mm hex version for compatibility with iFixit style mini-bits
- Changed the magnet to a larger 10mm diameter by 1.8mm thick rare-earth magnet. This magnet is able to hold the finger wrench to a magnetic surface (even upside-down!) and also holds the bit in the wrench.
- The magnet now mounts on the underside. I recommend using supports for the magnet cavity.
- Removal of all fillets and replaced with chamfers, which makes the underside print cleanly with no support (apart from inside the magnet cavity).
- Full source code included (SCAD and SVG)
- 4mm hex-bore is oversized by 0.46mm to compensate for well known issue with 3d printers undersizing holes
- 10mm magnet hole size is oversized by 0.4mm
See the source code for an equation developed by Joshua Kuhn in his 2015 Master's thesis relating to oversizing the 3d-model holes to get accurate holes in 3D prints: