1 / 4
BTT ADXL345 X/Y Mount and Clamp for Input Shaper Calibration — image 1
1 / 4

BTT ADXL345 X/Y Mount and Clamp for Input Shaper Calibration

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This clamp fits the BTT ADXL345 to the bed (on a bed slinger) and can mount to any M3 on the X axis.

Rating
5 / 5
Likes
2
Downloads
38
Makes
1
Views
278
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

This is a small carrier and mounting hardware to attach the BTT ADXL345 to the X and then Y axis of a bedslinger.    I use it on my Klippered Prusa MK3S+.  Then you can do the input shaping.

It is easy to print.  I used PLA.  Other pieces needed

1x ADXL345 Module: Amazon.com: BIGTREETECH ADXL345 V2.0 Accelerometer Board Klipper Input Shaping 3D Printer Hotend Parts Sensor Module Support USB Connection for Voron Stealthburner : Industrial & Scientific

4x M3 Nuts

2x M3x5mm  (ADXL to carrier)

2x M3x8mm  (carrier to clamp)

Assembly is pretty easy.  the 5mm can't be too much longer.  the 8mm could be longer if you only have 10mm on hand since they are all through-holes.  The nuts fit tight by design so they stay in the plastic.  I use a screw to pull them into the plastic and give them a little heat if needed.

Refer to the klipper documentation for flashing the device and also what to configure to perform the input shaping.

X: The carrier can screw directly into any M3 (on mine I use the spare one on the Bondtech).

Y: Attach the clamp bottom half to the carrier.  The clamp is tapered to give it some bite into the bottom side of the bed.  You can either tighten the screws or shim it if it needs to be even tighter.  

 

Tags