1 / 3
FemtoBox - Professional Case for Meshtastic Femtofox Node – Perfect Fit for LuckFox w/ Foxbuntu – Supports I2C, Serial IO, USB-C OTG, Ethernet, and the High-Power 1W E32-900M30s LoRa Module (816MHz/915MHz) – So Stylish, Your Node Will Thank You!
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case for the Femtofox Pro, a small, low power, Linux-powered Meshtastic node
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 72
- Makes
- 1
- Views
- 878
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my attempt at a very small case for the Femtofox Meshtastic node.
More information on the Femtofox can be found here: https://github.com/femtofox/femtofox
Some notes:
Additional Components:
- N Female to IPX/UFL RG178 Cable - 10 cm - https://www.aliexpress.us/item/3256801734648745.html
- 0.96 Inch OLED Display Module SSD1306 I2C IIC SPI Serial 128X64 LCD - https://www.aliexpress.us/item/3256804169233174.html
- M3x8mm screws to hold the case together
- M2.5x5mm screws to hold the screen
Some Notes:
- This is not an official case, but the fine folks who designed the Femtofox let me use a simplified version of their logo!
- Your prints will NEED SUPPORTS for this. I print them in the orientation implied by the STL. I use “tree type" supports for the mid frame, and traditional rectilinear supports for the covers.
- I put Kapton over the unused Pi header. The N-female connector comes really close to those pads and you don't want to have a short!
- I also used Kapton to keep strain off the IPX/UFL end of the antenna cable.
- You can fit an RTC, but its tight.
- I removed the pins on my OLED and just ran wires.
- The button pusher needs to freely slide. I filed/sanded off the burrs from printing to make sure it was a nice slip fit. (The odd shape is because I mis-located the hole in the case and I didn't want to redesign it!). The L part points away from the display.
- Use two small bits of clear PETG or tGlas filament as a light pipe down to the LuckFox LEDs. The holes were sized for my print settings, and hopefully they work for you.
You can find me in the Femtofox channel on Discord (https://discord.com/channels/867578229534359593/1329096340700921898) if you have any feedback.