Logitech Controller Speaker Cover
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.30 – €0.37 net (excluding VAT)
For file: Logitech Speaker Cover_0.4n_0.2mm_PETG_MINIIS_18m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.33 excluding VAT (range midpoint).
- Weight reported by the author
- 5 g
- Print time reported by the author
- 18.6 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Works with Logitech X-230 and probably similar 2.1 or 5.1 systems
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 42
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About
I had some Logitech X-230 speakers (2.1 setup) and the right speaker with a controller somehow lost the cover on it, so I redesigned that from scratch. Not great, not terrible.
Please give a like and post makes and provide comments for further improvements.
Changelog
- 2025.03.18 - initial release
Print:
- notice gcode file is just for generic info about filament and print time
- I suggest 0.2mm layer height
- 2 or more perimeters
- infill whatever you like but 25% is enough
- no supports, no brim
- you may want to tune infill angle to 0 (or 90) to make it a bit nicer.
Assembly
- you may want to sand the corners and paint the front to your liking
- after printing you need to heat up the plugs that go into the holes of the screws (can be done with a hot station or a lighter
- use a knife to expand them slightly, adjust it so it is not too much otherwise it is hard to slide in and they can break.