1 / 10
Logitech Controller Speaker Cover
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Works with Logitech X-230 and probably similar 2.1 or 5.1 systems
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 42
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
About
I had some Logitech X-230 speakers (2.1 setup) and the right speaker with a controller somehow lost the cover on it, so I redesigned that from scratch. Not great, not terrible.
Please give a like and post makes and provide comments for further improvements.
Changelog
- 2025.03.18 - initial release
Print:
- notice gcode file is just for generic info about filament and print time
- I suggest 0.2mm layer height
- 2 or more perimeters
- infill whatever you like but 25% is enough
- no supports, no brim
- you may want to tune infill angle to 0 (or 90) to make it a bit nicer.
Assembly
- you may want to sand the corners and paint the front to your liking
- after printing you need to heat up the plugs that go into the holes of the screws (can be done with a hot station or a lighter
- use a knife to expand them slightly, adjust it so it is not too much otherwise it is hard to slide in and they can break.