1 / 5
Duet Roto Toolboard mount for the Vz_Hextrudort-Low extruder — image 1
1 / 5

Duet Roto Toolboard mount for the Vz_Hextrudort-Low extruder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A mount for the Duet rototoolboard meant for the vzhextrudort-low air cooled version.

Rating
0 / 5
Likes
1
Downloads
4
Makes
0
Views
92
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This is a mount I designed for the Vz_Hextrudort-Low extruder and the Duet RotoToolboard. It's my second attempt as the prototype did not have enough strain relief for the big XT30_2+2 connector that the roto toolboard uses. This version has a snap that grabs the toolboard's cable as well as a clasp that screws in, holding the cable firmly in place. It also has a back clasp that can be used to hold onto any additional cables/wires. You will need to use the printed reverse bowden mount with the hextrudort, which I have included here for completeness. You'll also need the included spacer, which goes on the lower screw hole between the extruder and the mount. 

 

You'll need two of both the M4 and M3 type inserts. The heat set inserts are M4 6.3mm diameter 4.5m length, while the M3 inserts are 5.5mm diameter and 6.3mm long. I'm fairly certain they are both available from CNC Kitchen, though other inserts of similar dimensions should also work. 

 

Slightly longer screws for mounting are needed than the default hextrudort ones. Both M3 screws need to be M3x25 but the upper one should be a button-head type so it doesn't make contact with the back of the toolboard. The M4 screws should be M4x6.

Tags