Battlecruiser Starship and Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A spaceship and stand.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 93
- Makes
- 2
- Views
- 543
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
For my 500th submission, I wanted to do something a bit different. Most of my submissions have been artistic organic sculptures. So, I took it upon myself to design a hard-surface type of model. To this end, I created a battlecruiser-class starship with a cool stand to show off the model.
This model was NOT created with any use of AI.
This model has three versions: a hard-edged version, a soft-edged version and a supported version. The supported version is a model of the hard-edged version that has been hollowed out with holes for resin drainage in the engine areas. The supported version also has the plugs for the holes, but I wouldn't bother printing those - just delete the plugs - the holes look like part of the ship. The supported version is designed for resin printers but may work on FDM printers.
The model of the spaceship will need supports (unless you use the supported version). The model of the stand does not need any supports.
The spaceship and stand fit together with a dovetail joint. The stand fits the hard-edged version nicely (tested). However, the fit for the soft-edged version has not been tested. You may need to file the dovetail connector on the stand, but the tolerances should be close, so you shouldn't take much off.
If you resize the spaceship, ensure the stand is resized to the same percentage so the dovetail joint fits.