Drill press laser guide or crosshair

For 16mm drill press that column size around 74mm.

What you need: 

• 2 x 12mm laser pointer red line type ( model name: SYD1230 )
• 1 x 6mm 2 pins toggle switch
• 1 x USB cable any length 
• 2 x M5 12mm bolts or shorter
• 6 x M3 6mm screw
• 1 x 5 cm of black and red wires
• 1 x Any USB 5v power brick or powerbank
• 1 x 100mm ( 4 inch ) pipe clamp.

Print Setting:

• Layer height 0.24 or larger
• Print on the given orientation
• no supports needed

Wiring guide

Pardon me for this masterpiece.

1. Combine 2 pairs of laser black and red wires.
2. Extend it with extra 5cm cables.
3. Black go to 1 pin on toggle switch then other pin connect to black cable on usb cable.
4. Red go straight to red on usb cable.
5. Try to connect to power source then close the cover.
6. Done!

Noted 

• If you enjoy this model please consider to buy me some filament ( Paypal )