1 / 6
Anti vbration squash ball feet: Prusa mk4/mk3 — image 1
1 / 6

Anti vbration squash ball feet: Prusa mk4/mk3

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Three variants. Able to be used with each other: all have the same low profile vertical offset. Weight balancing.

Rating
0 / 5
Likes
5
Downloads
21
Makes
0
Views
201
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

I tried a couple of the other foot designs available, and I was really disapointed. They were weak or complicated to install, and none survived moving the printer in and out of the enclosure.

Design goals:

  1. Strength: ability to hold the entire weight of the printer on any single foot, for printer maintenence.
  2. Easy Installation: Ability to install the feet without removing the printer from enclose, or disassembling the printer.
  3. Minimize additional cost: You may be able to use the m5 bolts that come with the printer, but I got an assortment of m5 bolts and used longer ones (m5x16 or m5x20).
  4. Easy printing: only the vertically oriented foot is two pieces. And, no supports should be necessary.
  5. Counter massive weight imbalance: the left rear of the printer carries the majority of the weight of the printer, so much so that when using other designs, the printer would be tilted, with the left rear ball being massively squashed. So, I designed a double ball foot to address the problem. Presently, I have four balls on the left side (double ball left rear, one at the middle (using the narrow foot), and one at the front (using the wide foot), and on the right rear the vertical foot and a wide foot on the right front.
  6. Maximize Vibration damping: Grip the ball just enough to be stable, while allowing the ball to dampen movement. This also allows the ball to pop out before breaking the foot, if it gets bumped hard.

Printing:

  1. I used random discounted ABS+. In the slicer I used _ABS Pro Flashforge preset, and turned down nozzle and bed temps to match the label on the filament roll. I printed with ramping, 0.4 nozzle, 0.15 layers. Tried the variable layer setting too, and it worked well.
  2. Preheated the enclosure to 40c. Used Elmers school glue stick on generic textured build plate.
  3. The vertical two piece foot will accept a 3mm bolt to join the pieces, but it should not be necessary.

Installation:

You should be able to add these feet to a mk4 in it's enclosure, while it's still tethered to the remote lcd screen. It's likely you may have to unplug the power cable though to get the left rear double ball foot mounted.

It seems easiest to install the wide feet on the front first, then the vertical feet at the middle, then the right rear (which could be a wide or vertical foot) and lastly the left rear double foot.

  1. Remove the m5 bolts at a corner of the frame.
  2. Put them (or recommended longer m5x20 or m5x16) through the foot and screw into the frame.
  3. Push a squash ball into the spherical receiver
  4. Enjoy the silence.

Tags