1 / 13
Wireless charging base for MG3 Hybrid+
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This gadget seamlessly adds wireless charging to the MG3 Hybrid+. It uses a Qi charger and an anti slip pad.The anti…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 22
- Makes
- 0
- Views
- 426
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This gadget seamlessly adds wireless charging to the MG3 Hybrid+. It uses a Qi charger and an anti slip pad.
The anti slip pad is optional, but ensures the phone will keep charging even during a rough drive.
This design do not use the provided USB ports because the power is not sufficient for a fast and stable charge (but you can try anyway with a slightly longer cable).
Parts needed:
- Qi Charger (https://www.amazon.it/dp/B0CXDLWLDK), it should work with any charger about 85mm diameter and 7.4 mm height
- 12V USB Charger
- 30cm USB cable (USB-C to USB-C)
- Anti slip pad (https://www.amazon.it/dp/B0DD435X1M)
- 4x M3x8 flat head screws
- 4x M3 hex nuts
- Hot glue (to show the charger's LED)
Steps:
- Print all parts
- Push the anti slip support into the charging base top (see photo)
- Push the hex nuts into their sockets
- Place the wireless charger and use hot glue to connect the LED light to the light hole
- Connect the USB cable (see photo)
- Close the cover with the 4 screws
- Place the logo (use glue if needed) and the anti slip pad