1 / 2
Nikon Battery Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Battery and SD Card holder for the EN-EL3e and EN-EL15
- Rating
- 5 / 5
- Likes
- 159
- Downloads
- 912
- Makes
- 6
- Views
- 3,482
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Share Alike
Printed in PETG at .20mm slicing on a prusa mk3s+.
The battery is shaped for the larger EN EL-3e battery. But will still fit the more common and smaller EN-EL15.
It should fit a 70mm diameter by 3mm thickness O-ring if you would like to seal for water tightness.
It's a pretty tight fit, so I put a bit of krytox lubricant on the threads and screwed them on and off a few times.
I updated the lid to allow the base to screw in easier. At some angles the base was hard to screw into the lid.