RAK IPEX pigtail bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bracket to secure IPEX antenna pigtails to your RAK Wisblock
- Rating
- 3 / 5
- Likes
- 33
- Downloads
- 152
- Makes
- 2
- Views
- 1,501
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Often the thought in the back of our mind, after we worked hard to mount that solar Meshtastic node in a hard to reach location: “Did my IPEX pigtail pop off the mount due to it being loose, or too much tension on it?” and “Is my un-attached bluetooth and LoRa antennas burning holes in my transmitter?”.
This will snap into place on a RAK4631 mounted to any of these boards:
- RAK19007
- RAK19003
- RAK5005-O
While it will give insurance just by itself, i've also added the option to add m2 screws to further tighten the IPEX connectors. Works with m2 x 4mm machine screws or longer. Recommend nylon over metal machine screws for best antenna performance.
Settings:
- Print sideways orientation for strength
- PETG filament or better if it's going to be outdoors
- Don't use carbon fiber
- 0.16mm Layer Height
- 3 Wall loops
- 15% Gyroid infill