RAK IPEX pigtail bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket to secure IPEX antenna pigtails to your RAK Wisblock
- Ocena
- 3 / 5
- Polubienia
- 33
- Pobrania
- 152
- Wydruki
- 2
- Wyświetlenia
- 1501
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Often the thought in the back of our mind, after we worked hard to mount that solar Meshtastic node in a hard to reach location: “Did my IPEX pigtail pop off the mount due to it being loose, or too much tension on it?” and “Is my un-attached bluetooth and LoRa antennas burning holes in my transmitter?”.
This will snap into place on a RAK4631 mounted to any of these boards:
- RAK19007
- RAK19003
- RAK5005-O
While it will give insurance just by itself, i've also added the option to add m2 screws to further tighten the IPEX connectors. Works with m2 x 4mm machine screws or longer. Recommend nylon over metal machine screws for best antenna performance.
Settings:
- Print sideways orientation for strength
- PETG filament or better if it's going to be outdoors
- Don't use carbon fiber
- 0.16mm Layer Height
- 3 Wall loops
- 15% Gyroid infill