1 / 6
Lens Caps (one part print) - 40.5 mm, 52 mm, 58 mm - Added support under springs — image 1
1 / 6

Lens Caps (one part print) - 40.5 mm, 52 mm, 58 mm - Added support under springs

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Lens caps in various sizes (40.5, 52, 58) printed as one part.

Rating
5 / 5
Likes
13
Downloads
271
Makes
5
Views
733
Reviews
5

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Changes:

  • Added small supports under the springs, as with PETG I was getting spaghetti.
  • Added x40.5 model with extra depth
  • Added 58 model with normal depth

Available sizes:

  • 40.5 mm + x40.5 mm with extra depth
  • 52 mm + x52 mm with extra depth
  • 58 mm + x58 mm with extra depth

Print the same as with Boopidoo's version (no support!!!).

Print without support. After print, place the cap with button towards a hard surface and push firmly until it snaps loose. Do the same for the other side. There's only a 0.3mm gap in the design so it will probably stick together somewhat. I've printed in 0.15mm PLA and PETG.

Samsung and Fujifilm logo was added in OrcaSlicer.

Tags