Hydroponic Tower Adapter: Gamma2 Bucket Lids
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lid Adapter for the Modular Hydroponic Tower https://www.printables.com/model/720081-modular-hydroponic-tower.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 41
- Makes
- 0
- Views
- 453
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
The Gamma2 buckets come with a screwable lid (vs lids that “snap” on) and a cross section directly through the center. This is an adapter which connects to the Modular Hydroponic Tower https://www.printables.com/model/720081-modular-hydroponic-tower. The bottom of the adapter is slanted slightly to allow appropriate water drainage into bucket below. The center & bottom of the adapter has a pass-through which will drain water into the bucket (not onto the lid).
Non affiliate link to bucket & lid: Amazon
Supports Required.
The bottom of adapter can receive 4 threaded inserts (M4) (see rendered photos - hence, the build-up of material in the 4 quadrants). Directly above the insert holes is a smaller hole for drilling pilots through the adapter into the lid – for correctly spacing the holes in the lid which the M4 bolts will pass through.
Sequence:
- Print Adapter
- Use hole saw to cut hold in center of “Gamma2” lid > 42mm (I used a 2 1/8" one)
- Place adapter on lid & drill pilot holes through lid
- Install threaded inserts in adapter
- Mount adapter to lid