Hydroponic Tower Adapter: Gamma2 Bucket Lids
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lid Adapter for the Modular Hydroponic Tower https://www.printables.com/model/720081-modular-hydroponic-tower.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 453
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
The Gamma2 buckets come with a screwable lid (vs lids that “snap” on) and a cross section directly through the center. This is an adapter which connects to the Modular Hydroponic Tower https://www.printables.com/model/720081-modular-hydroponic-tower. The bottom of the adapter is slanted slightly to allow appropriate water drainage into bucket below. The center & bottom of the adapter has a pass-through which will drain water into the bucket (not onto the lid).
Non affiliate link to bucket & lid: Amazon
Supports Required.
The bottom of adapter can receive 4 threaded inserts (M4) (see rendered photos - hence, the build-up of material in the 4 quadrants). Directly above the insert holes is a smaller hole for drilling pilots through the adapter into the lid – for correctly spacing the holes in the lid which the M4 bolts will pass through.
Sequence:
- Print Adapter
- Use hole saw to cut hold in center of “Gamma2” lid > 42mm (I used a 2 1/8" one)
- Place adapter on lid & drill pilot holes through lid
- Install threaded inserts in adapter
- Mount adapter to lid