Multiboard Flush Snap Pusher
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small tool to help push Flush Snaps into their Multiboard counter parts.
- Rating
- 5 / 5
- Likes
- 152
- Downloads
- 1,598
- Makes
- 11
- Views
- 6,219
- Reviews
- 19
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Public Domain
Since the new Flush Snaps are a little flimsy, it can be difficult to push them into their Multiboard counter parts - especially if you chose the tighter versions.
So I made this little tool to help with that.
Print settings
I print these with the default Multiboard settings:
- 3 perimeters
- 0.2 mm layer height
- 15% infill
simukis suggested on Reddit to print these with more top and bottom layers since his failed after 20+ snaps.
Updates:
2025-05-16: Added two new variants after Lucky Green's suggestions. They include a square marking on both sides that help aligning the directional snaps. The holding part of the small version is 5 mm longer and I've added a big version too. I am not sure how well the big one works, because you can't really see the Snaps on the wall anymore, but if you want to whack it with a hammer, it might be more safe ;-).