Philips MG3720 Comb 20mm and 15mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A comb attachment that clips hair and beard at 20mm and 15mm. All parts are printed flat, no need for support material.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 62
- Makes
- 0
- Views
- 432
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Men
- License
- Creative Commons — Public Domain
Factory-made combs were available up to 9mm. I needed 15mm and 20mm combs to trim my beard. The problem was that it was a very difficult piece to design.
Thanks to our friend Lynlimer, he modeled the 25mm version perfectly. I printed it out and BAM!, everything fell into place. All that was left was to shorten the comb pieces a bit.
…and now available in 15mm and 20mm versions.
3D Print tips from original model;
Print all parts flat at bed.
No support material needed.
All combs slides in place.
When all combs are slided at place, make sure they are aligned well, and glue them through the slide slits with CA glue.
Glue the “ base under” on base, this will make the combs stiffer.
Good luck with your haircut!
Lynlimer…