Sequential Shifter Handbrake buttonbox combo V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Video Games
- License
- Open Community License v1
Held on a playseat challenge thanks to this design: https://www.printables.com/model/302265-playseat-challenge-shifter-holder-shortened-attach
The controller board and wires https://retroactivearcade.ca/products/110-zero-delay-arcade-encoder?_pos=4&_sid=8b09b8038&_ss=r
buttons https://retroactivearcade.ca/products/sanwa-obsn-24mm-orange?_pos=40&_sid=6a8250a35&_ss=r
Switches: Generic microswitches with metal blade
Springs: Generic
The levers are using M4 screws with 2 greased washers on each side of them to dampen
Same screw as the lever is used to hold the PCB tray
Can put springs on top or bottom of system, bottom springs use the switch brackets, top are held directly on the screws for the brackets (see pictures for top)
Either side can be a shifter or a handbrake, mine has the handbrake left and shifter right
Handles are printed at 100% infill because it feels good :)