Runcam6 mount for Xcalibur turbine RC jet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount interface to enable the attachment of a Runcam6 camera to the tail of an Xcalibur RC turbine jet (standard size)
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 113
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Designed to use the existing wingbolts of the aircraft, it can be mounted on either the left or right side of the tailplane (or both). Runcam6 holder is retained with the separate (green) piece which is screwed down with a countersunk M3 x 8mm screw and the nut is retained in the print.
I printed with ASA for strength and use outdoors when flying. 0.15mm layer height with 4 perimeters, about 10% infill and a brim (because ASA lifts). The main piece was printed with support material under the curved section, as that side is mounted to the wing and is hidden so it doesn't matter how difficult the support material is to take off (I sanded it). The retainer was printed upside down.
The model is a 3MF file with two bodies, just separate them on the print bed or print them separately using the two different files.
I've had almost 20 flights with the camera mounted on the tail with no issues. A couple of flight videos uploaded to YouTube @rustynail252