Small Cable Holder / Clip - under the table
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small cable holder/clip to be used under the desk or work surface. Used for thinner wires like a mouse, keyboard etc.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 93
- Makes
- 5
- Views
- 386
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
A very quick and simple design of cable holder / clip to be used under the desk or work surface. Due to small dimensions, it is to be used with thinner wires like a mouse, keyboard, headset etc.
Printed on MK3S+, with PLA in 0.3mm draft settings.
Position model flat on the side, no supports needed.
Available files:
STL
“Cable_Clip_screw.stl” - STL to be used when fixing the clip with screw to the surface.
“Cable_Clip_nail.stl” - STL to be used when fixing the clip with nail to the surface.
“Cable_Clip_no_hole.stl” - STL to be used when fixing the clip with glue/tape etc. to the surface.
Gcode
“cable_clip_nail_0.3mm_PLA_MK3S_8m.gcode” - ready to print nail version
“cable_clip_screw_0.3mm_PLA_MK3S_8m.gcode” - ready to print screw version
“cable_clip_no hole_0.3mm_PLA_MK3S_8m.gcode” - ready to print no hole version
If you need more of them, don't print 1 by 1 as that is the slowest option.
Use STL to align more as each additional takes only 4 more minutes instead of standard 8.
Average print times:
1clip - 8min, 2clips - 9min, 3clips - 13min, 4 clips - 17min, 5 clips - 21min