ELRS for TBS Tango 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Beta fpv nano tx V2 internal mount for TBS tango 2
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 32
- Makes
- 1
- Views
- 588
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Mounting bracket for ELRS module Beta fv nano tx V2 with stock fan
You will need the Happymodel Tango 2 Power Adapter for this mod
As the beta fpv module is a little larger than the happymodel one, you will need to mod your Tango a little. I trimed a little the casing as shown in the third picture, and removed about 4-5 mm on the power button.
Also you will need to remove the 3.5mm audio outpout and jump wire the two pads shown in the fourth picture.
On the module you will need to remove the USB-C connector (after updating your ELRS module first), the SMA connector (i replaced it with a UFL connector) and the plastic connector connecting the daughter board to the mother board. Then I sanded the module à little at the top and bottom for an easier fit.
I did fit an antenna in the original antena of the tango 2
To print the support I recommend to do it with ABS as the module can get hot, and you will need supports
To lock the assembly I used a dab of hot glue for easy removal if needed