1 / 11
Philips Hairclipper QC5050, QC5010 Head Repair
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for Philips QC5050/QC5010 hair clipper's head part. Restores cutting performance and fit. Easy to install.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 12
- Makes
- 0
- Views
- 214
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
Print Settings
Rafts: Doesn't Matter
Supports: Yes
Repair Instructions for Philips Hair Clipper Head (QC5050/QC5010):
- Disassemble the head and remove the broken plastic part. (Mine broke where the arrow indicates—poor design choice!)
- Slightly bend each end of the spring and insert them into the designated holes.
- Insert the printed replacement part into the square slots. PLA works fine, but nylon is even better. You may need to use a small file for a perfect fit.
- Use a heated iron to melt and secure the outer tips of the two extruded rectangles to lock the part in place.
- Reattach the razor and insert the spring ends into the holes on the razor.
- Reassemble the head back into the shaver.
- If the clipper sounds noisy, slightly reduce the size of the cylinder’s movement hole and reprint. If the motor struggles to start, widen the slot slightly using a needle file.
For smoother movement, brush the slot with dichloromethane (for PLA) or formic acid (for nylon).