1 / 1
Arrma 7.5x8mm 6S Shock Bushing
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is required to use 6S shocks on a 3S vehicle and should only be needed for the top eyelets.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 33
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This should be printed in the lowest Shore TPU you can print with. I used Ninjatek Ninjaflex 85A. 6 walls will give you a solid print. Circled in black/left in my photo is the original file, printed with a random seam, so the middle is a little ugly. The white/right one was printed with the fillets and an aligned seam. Both are upside down from their printed orientation, so the underside is visible on the bottom. I printed four of these together in about 14 minutes on an Ender 3v2 with a MicroSwiss direct drive.