M6 Universal Battery Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A holder designed for in-situ studies of batteries up to 4680 in size. Secured by M6 bolts to a metric breadboard.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Chemistry & Biology
- License
- GNU Lesser General Public License
A “universal” battery holder, designed to securely hold batteries up to the size of the Tesla 4680 for tomography and/or diffraction studies, without damaging the cell and allowing for in-situ charging/discharging and temperature monitoring.
The holder has 4 counterbore and 8 regular M6 holes, and is designed to attach to a metric optical breadboard with M6 tapped holes spaced 25mm apart (such as those made by Throlabs or Edmund Optics). The central recess is sized for an A/AA spring contact, which can be soldered to a wire that can be guided via one of the two horizontal or one vertical through-holes, sized for wires up to 18 AWG (where the central vertical through-hole is designed for attaching contacts to a slip ring). Two additional vertical+horizontal guides are included for wiring temperature sensors. The battery is secured in the holder by means of two nylon M3x10 screws that attach to M3 brass threaded inserts (these can be heat-set pressed into the two vertical counterbore holes).
The holder is considered “universal” by the use of battery type-specific inserts. As per the images, an insert for an AAA battery is demonstrated, which uses a similar combination of A3 inserts and screws for securing the battery inside the insert. FreeCAD models of the holder and insert are included, which can be modified for different battery sizes.
The following should be considered when printing the models:
- Material: Any non-brittle, lightly attenuating material suitable for the experiment (I used PLA as it does not attenuate or rapidly degrade in >50 keV X-rays)
- Layer height: 0.3 mm recommended
- Strength: 4-5 perimeters, 1 mm top and bottom minimum shell thickness, infill is less important (but I had good results with 15% gyroid)
- Support: No supports, no brim
- Count: 1 holder (bottom) for ex-situ studies, 2 holders for in-situ studies (bottom+top, both identical models)
The following should be considered when assembling the models:
- Heat-set the M3 inserts (two per part), ensuring that they don't protrude into the cylindrical battery slot
- Solder an 18 AWG wire to the bottom of the spring contact, then guide the wire through the central vertical hole or one of the two horizontal holes
- The spring contact can be super-glued or gently heat-set into the central recess
- It is recommended that the other end of the wire be permanently connected to an insulated terminal block for a reliable connection and to avoid accidental contact with another wire or a conductive surface
- When using two holders (in a top and bottom configuration), it is recommended that the two wires are colour-coded based on the battery polarity