1 / 11
Spiggytech X300U-A Thumb Stop Grip Assist — image 1
1 / 11

Spiggytech X300U-A Thumb Stop Grip Assist

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a modification to the Surefire X300U-A adding a thumb stop for enhanced grip assistance

Rating
5 / 5
Likes
16
Downloads
339
Makes
1
Views
1,321
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

This is a modest upgrade to the Surefire X300U-A by replacing one or both of the existing rail clamps with an extension piece. 

Background: These were iteratively developed in about 9 stages. I later found out similar products already exist on the market, but I have a 3D printer and no patience to wait for shipping. 

 

The mod offers three faces for enhanced grip:

  • The first face is towards the shooter allowing assist with forward thumb pressure. 
  • The top serrated surface allows for downwards thumb pressure.
  • The forward curved surface allows for the thumb to pull with backwards pressure. 

 

The mod is also produced in both left hand and right hand. As well as Three standard lengths. Short (27mm), Medium (31mm), and Long (36mm) to accommodate a variety of handguns and thumb preferences.

 

Print Instructions: 

Print 100% infill using a stiff and strong material. I've tested with Bambu X1C PAHT-CF and Fiberon PET-CF (note, NOT PETG). Use a raft as the bottom line can get pretty thin. 

 

Pre-Installation Check: 

When printing, always check your hole diameters. If they're too small like seen here. It's smart to drill the holes out to 2.15mm, or a #44 drill bit. If you're like me and don't own a full drill kit. You can use the stock screws. Just screw them in and bottom it out to ensure the holes are to size. This is important as it will push extra material out that could get stuck inside your flashlight and cause a snapped screw. Ok. I've warned you.  

 

Installation Instructions:

  1. Do the thing I mentioned above in Pre-Installation Check. 
  2. Remove the original clamp
  3. Install the thumb stop
  4. Don't tighten too hard or you can snap a screw
  5. Check fitment on your handgun
  6. Grab a soda because you deserve it

 

For any questions, comments, or suggestions. Please feel free to reach out. 

Tags