Air Assist for Creality Falcon 10W
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Air Assist Nozzle and piece for the tube. Attached with M3 Screws.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 172
- Makes
- 0
- Views
- 761
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Public Domain
Air Assist for Creality Falcon 10W, does not require cutting the original acrylic, this will replace it. Height is same as in original cover, so the calibration stays the same.
I already had a compressor, so I designed this. I use a air brush compressor. I bought a normal pneumatic hose, outer diameter 6mm and inner diameter 4mm.
There is M3 screws in the laser module, i just screwed those out and used hex screws to mount cover to the module.
TubeBend-bit acts as tube holder. Just remove original spacers from laser module and replace those with TubeBend-bit. See picture for better explanation.
Layer height: 0.12mm
Material: PLA
Support: yes, only against the buildplate.
Filling: 15%
Thanks and have fun printing, any ideas for improvement can be shared in the comments.