1 / 1
E3NG V1.2 (PCB) Klicky Dock M2 Magnet Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified the dock to take an M2 screw for securing the magnet as included in the PCB Klicky kits.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 53
- Makes
- 0
- Views
- 323
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The original Klicky dock has a slot for a magnet, to hold the Klicky probe in place.
There is a 2.3mm hole underneath the magnet by default, which is too big to thread in an M2 screw, but too small for an M2 heat set insert.
An M2.5 screw would thread perfectly, but this does not fit through the magnets.
I modified the dock to have a 1.8mm diameter hole so you can screw the magnet down properly without needing any glue.