Creality Space Pi Plus Heat Deflector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fixes E4 error on Space Pi filament drier
- Rating
- 5 / 5
- Likes
- 198
- Downloads
- 1,194
- Makes
- 20
- Views
- 4,020
- Reviews
- 18
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Update: 2025-05-15
I've removed the bambu exclusive restriction and have set the license to allow remixes.
Have seen a few other variants out there, but wanted something that was a little more minimalist as I have no need of silca bag storage since I use https://makerworld.com/en/models/627915#profileId-552556 with my Space Pi Plus. Modeled up the internals for this and a couple hours later this little guy popped out of the printer. Tested it up to 65C for a couple of hours with no vissible warpage. I do not recommend printing this with anything less an ABS for heat resistance since the temperature it gets exposed to is way higher then the set temp.
For reference here is bambu's table of material properties, https://bambulab.com/en-us/filament/guide , 5th row is heat resistance. PETG is almost 20C lower than ABS for Bambu's materials. This will very for other materials, but either way don't use PETG.
Shout out to https://makerworld.com/en/models/941146#profileId-907000 and https://makerworld.com/en/models/815728?designId=815728#profileId-757937 for the inspiration behind this.