Wire Straightener
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.24 – €2.74 net (excluding VAT)
For file: Wire Straightener v1 washer_0.4n_0.2mm_PLA_XLIS_2h10m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.49 excluding VAT (range midpoint).
- Weight reported by the author
- 38 g
- Print time reported by the author
- 2.16 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Sometimes you want to pull your wire. Other times you want it straightened out. This tool's got you covered.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 66
- Makes
- 0
- Views
- 655
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Simple three bearing wire straightener. Hook the offending copper zap-snake under the front bearing, over the middle one, and under the third. Stroke it. Stroke it good. There, now it's straight.
I printed mine in petg, 5 perimeters all around, top and bottom. 15% gyroid infill works fine for me.
Requires a dab of the good sticky (I use gorilla glue clear) in the handle to hold it together. Maybe not depending on your printer tolerances as it's friction tight by design.
You'll need 3x 608rs bearings and 3x 5mm rubber o-rings to assemble this tool.
Share. Enjoy. Give that wire a good tug.